Canon ir2016, ir2020 マニュアル
Chapter 3
3-15
F-3-90
4) Remove the two RS tightening screws (M3 x 8) [1], and then remove the
finisher controller PCB [2] together with the mount.
F-3-91
5) Remove the timing belt [1].
F-3-92
3.5.5 Front Cover Safety Switch
3.5.5.1 Removing the Top Cover
0010-6697
1) Remove the three RS tightening screws (M3 x 8) [1], and then detach the
top cover [2].
F-3-93
3.5.5.2 Removing the Inlet Guide
0010-6698
1) Remove the stepped screw [1] (front side) and RS tightening screw (M3
x 8) [2], and then remove the inlet guide [3].
F-3-94
3.5.5.3 Removing the Front Cover Safety Switch
0010-6699
1) Remove the RS tightening screw (M3 x 8) [1]. Remove the two reusable
bands [2] using pliers or the like, and then remove the harness from the edge
saddle [3].
2) Remove the harness [5] from the guide [4], and then remove the front cov-
er safety switch [6].
F-3-95
3.5.6 Inlet Sensor
3.5.6.1 Removing the Top Cover
0010-6676
1) Remove the three RS tightening screws (M3 x 8) [1], and then detach the
top cover [2].
[5]
[4]
[1]
[2]
[1]
[1]
[2]
[1]
[3]
[2]
[5]
[2]
[6]
[4]
[3] [1]