Canon ir2016, ir2020 マニュアル
Chapter 3
3-17
F-3-102
4) Remove the two RS tightening screws (M3 x 8) [1], and then remove the
finisher controller PCB [2] together with the mount.
F-3-103
5) Remove the timing belt [1].
F-3-104
3.5.7.4 Removing the Inlet Guide
0010-6686
1) Remove the stepped screw [1] (front side) and RS tightening screw (M3
x 8) [2], and then remove the inlet guide [3].
F-3-105
3.5.7.5 Removing the Front Cover Safety Switch
0010-6688
1) Remove the RS tightening screw (M3 x 8) [1]. Remove the two reusable
bands [2] using pliers or the like, and then remove the harness from the edge
saddle [3].
2) Remove the harness [5] from the guide [4], and then remove the front cov-
er safety switch [6].
F-3-106
3.5.7.6 Removing the Drive Unit
0010-6689
1) Remove the three TP screws (M4 x 12) [1], one RS tightening screw (M3
x 8) [2], and the drive unit [3].
F-3-107
3.5.7.7 Removing the Process Tray Unit
0010-6691
1) Remove the stepped screw [1] (rear side) and RS tightening screw [2]
(front side), and then remove the stay [3] and process tray [4] (right side).
F-3-108
2) Remove the stepped screw [5] (front side) and RS tightening screw [6]
(rear side), and then remove the process tray [7] (left side).
[5]
[4]
[1]
[2]
[1]
[1]
[3]
[2]
[5]
[2]
[6]
[4]
[3] [1]
[1]
[2]
[3]
[2]
[4]
[3]
[1]