Canon ir2016, ir2020 マニュアル
Chapter 3
3-19
F-3-116
3.5.8.4 Removing the Offset HP Sensor
0010-6696
1) Remove the P tightening screw (M4 x 10) [1], and then detach the sensor
cover [2].
F-3-117
2) Disconnect the connector [3], and then remove the offset HP sensor [4].
F-3-118
3.5.9 Tray Clock Sensor
3.5.9.1 Removing the Stack Tray Harness
0010-6781
1) Disconnect the connector from the stack tray lower limit sensor [1]. Open
the two wire saddles [2], and then remove the harness from the reusable band
[3].
F-3-119
3.5.9.2 Removing the Tray Guide Top Cover
0010-6783
1) Remove the two RS tightening screws (M3 x 8), and then detach the tray
guide top cover [2].
F-3-120
3.5.9.3 Removing the Stack Tray Assembly
0010-6784
1) Turn the dial (1)[1], and then remove the stack tray [2].
F-3-121
3.5.9.4 Removing the Tray Clock Sensor
0010-6785
1) Remove the harness from the four wire saddles [1] and three mini-clamps
[2], and then remove the four binding screws (M3 x 3) [3].
2) Disconnect the connector [4], and then remove the tray clock sensor [5].
[1]
[1]
[2]
[4]
[3]
[3]
[1]
[2]
[1]
[2]
[1]
[2]
[3]
[3]
[3]