Canon ir2016, ir2020 マニュアル
Chapter 3
3-20
F-3-122
3.5.10 Offset Solenoid
3.5.10.1 Removing the Top Cover
0010-6701
1) Remove the three RS tightening screws (M3 x 8) [1], and then detach the
top cover [2].
F-3-123
3.5.10.2 Removing the Offset Solenoid
0010-6702
1) Disconnect the connector (J911) from the finisher controller PCB, and
then remove the harness from the edge saddle [1] and guide [2].
2) Remove the two binding screws (M4 x 4) [3], and then remove the offset
solenoid [4].
F-3-124
3.5.11 Paper Holder Solenoid
3.5.11.1 Removing the Top Cover
0010-6704
1) Remove the three RS tightening screws (M3 x 8) [1], and then detach the
top cover [2].
F-3-125
3.5.11.2 Removing the Inner Cover of the Finisher
0010-6705
1) Open the front cover of the host machine.
2) Remove the four RS tightening screws (M3 x 8) [1], and then detach the
rear cover [2].
F-3-126
3.5.11.3 Removing the Finisher Controller PCB
0010-6706
1) Remove all connectors from the finisher controller PCB [1], and then open
the two wire saddles [2].
2) Open ten wire saddles[3] and then remove the harnes.
F-3-127
3) Remove two wire saddles[4] behind the finisher controller, and then re-
move the harnes[5].
[1]
[4]
[5]
[2]
[3]
[3]
[1]
[2]
[4]
[3]
[2]
[1]
[1]
[2]
[1]
[2]
[1]
[2]
[3]
[3]
[3]