HP 20-700 ユーザーズマニュアル

Chapter 3

Initializing and Resetting the Library

Chapter 3

Initializing and Resetting the Library

Powering on the library causes it to initialize components and perform an

Initial Program Load (IPL). During initialization, the library prepares the robot

for operation and audits any cartridges in the storage and reserved cells.

During an IPL, the library loads the operating code and automatically verifies

some configuration values, such as drive locations and drive types.

Re-initializing the Library

You will have to re-initialize the library in the rare instance when a robotic

component malfunctions. Before re-initializing the library, perform any

necessary manual operation tasks (see

To re-initialize the library, make sure that all drives are powered on and

perform one of these actions:

■

Power off and power on the library (also causes an IPL)

■

Open and close the front door

Resetting the Library

You will have to reset the library when:

■

You are directed to do so by your system administrator or a service

representative

■

You have to change the library configuration (for example, when you have

to change the library’s SCSI ID)

To reset the library after it is already powered on, make sure that all the drives

are powered on and press the [RESET] button on the operator panel.