HP ProLiant ML330 G6 ユーザーズマニュアル
Hardware options installation 46
•
UDIMM
o
First: A and B
o
Last: D and E
o
Do not populate slots C, F, G, H, or I.
After installing the DIMMs, use RBSU to configure the system for Lockstep memory support ("
).
Installing DIMMs
CAUTION:
To avoid damage to the hard drives, memory, and other system components, the
air baffle, drive blanks, and access panel must be installed when the server is powered up.
1.
Power down the server (on page
2.
Do one of the following:
o
Open or remove the tower bezel, as needed ("
o
Extend the server from the rack (on page
3.
Remove the access panel (on page
4.
Remove the air baffle (on page
5.
Open the DIMM slot latches.
6.
Install the DIMM.
7.
Install the air baffle.
8.
Install the access panel (on page
9.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
10.
Power up the server (on page
After installing DIMMs, configure the AMP mode in RBSU ("
).