Juniper CBL-M40-PWR-AU ユーザーズマニュアル
Install the Router and Configure Software
Install the Router without Using a Mechanical Lift
115
Figure 40: Reinstall an FPC
Reinstall the Cable Management System
The cable management system is located at the top front of the chassis, above the card cage
(see Figure 1). If you removed it in “Remove the Cable Management System” on page 104,
follow this procedure to reinstall it:
(see Figure 1). If you removed it in “Remove the Cable Management System” on page 104,
follow this procedure to reinstall it:
1.
Attach an ESD strap to your bare wrist and connect the strap to one of the ESD points on
the chassis.
the chassis.
2.
Place the cable management system on the chassis, aligning the screws on its faceplate
with the mounting holes on the chassis (see Figure 41).
with the mounting holes on the chassis (see Figure 41).
3.
Using a Phillips screwdriver, tighten the screws.
4.
Replace the cable management system cover and tighten its captive screws to the top of
the metal prongs at either end of the cable management system (see Figure 42).
the metal prongs at either end of the cable management system (see Figure 42).
Figure 41: Reinstall the Cable Management System
1060
LEDs and offline
button
button
FPC
Extractor clip
Thumbscrew
1075