Sony SNCCX600 ユーザーズマニュアル

Ad
minis

tra

ting t

he Camer

a

Setting the Security — Security Menu

35

You can access the camera even from a computer having 
an IP address whose access right is set to Deny, if you 
enter the user name and password set for the 
Administrator boxes in the User menu. 

Configure the SSL or TLS function (called “SSL” 
hereafter). The settings allow the camera to 
communicate with the client PC by using SSL.

• The model on sale in China does not support the SSL 

function.

• When using the SSL function, always configure the 

settings after setting the date and time of the camera. 
If the date and time are not correctly set, it may cause 
browser connection problems.

• Reload the window when you change the SSL setting. 

Press the F5 key on the keyboard to reload.

SSL function
Select Enable to use the SSL function.
When Enable (Allow HTTP connection for some 
clients) is selected, both HTTP and SSL connections are 
allowed. When Enable is selected, only SSL connection 
is allowed.

When Internet Explorer 7, Internet Explorer 8, 
Internet Explorer 9 or Internet Explorer 10 is used
When SSL session is established, 

 appears in the right 

of the address bar on your web browser.

When you use SSL connection for the first time
When you use SSL connection only with the SSL 
function Enable, you cannot access the camera if the 
SSL function does not work properly.
In this case, you must reset the camera to the factory 
settings. (All settings will be initialized.)
To avoid this, check that SSL connection is possible by 
performing the following steps.

Set the SSL function to Enable (Allow HTTP 
connection for some clients).

Click OK to close the viewer and the setting 
window.

Display the viewer in SSL connection.
Refer to “Using the SSL function” on page 6 for 
connection.

After confirming that SSL connection is possible, 
set the SSL function to Enable.

Even if the setting window or the browser is closed as 
SSL connection is impossible, http connection will be 
possible if Enable (Allow HTTP connection for some 
clients) is selected. First check the setting contents of 
SSL tab in http connection, then check the SSL 
connection again.

If Enable (Allow HTTP connection for some clients) 
is not selected, you will not be able to access the camera 
if SSL connection becomes impossible. In this case, turn 
on the power of the main unit while pressing the reset 
switch on the camera to initialize. For details, refer to the 
supplied Installation Manual.

SSL connection will load the camera down; therefore, 
not all images may be downloaded, and the 

 mark 

may appear when the camera accesses the setting 
window from the browser. In this case, reload the 
window. Press the F5 key on the keyboard to reload.

Select an installation mode of the certificate.

Use an external certificate: Uses the certificate 

including private key information issued by a CA. 
The PKCS#12 and PEM formats are supported.

SSL is not available when Certificate options-Use an 
external certificate is selected, or certificate and private 
key password is not set properly even SSL is set to 
“Enable”.

Use a self-signed certificate (For test use): This mode 

uses the certificate and private key pair generated by 
“Self-signed certificate generation” on page 36. 
Private key information corresponding to the 
certificate is stored in the camera.
You do not need to install an external certificate.
However, you cannot execute the existence proof that 
is one of the SSL functions for the following reasons.
– The private key generated in the camera is self-

signed by the camera.

– A prepared value is set for a distinguished name 

(Common name, etc).

– The certificate is not issued by a trusted CA.