Electrolux 506029 ユーザーズマニュアル
ENGLISH
19
Cleaning the pump filter
•
Remove the pump filter “M” and clean any food trap-
ped in filter.
ped in filter.
Figure 21
Clean the tank
•
Open the door for access to the tank (Figure 22):
-
lift the lever “S” and pull the door outwards;
-
gently lower the door.
•
Clean the tank using a water spray to flush waste out
through the drain outlet.
through the drain outlet.
Figure 22
Carry out the above operations in the reverse order to
re-assemble all the previously disassembled parts.
re-assemble all the previously disassembled parts.
•
Replace the door (Figure 22):
-
Lift the door as far as movement permits (horizontal).
-
gently push the door inwards to prevent it from tilting.
-
Insert the levers “U” into their seats and push the
door until the slide blocks are no longer visible. Ope-
rations have been accomplished correctly if the
actual door closes properly.
door until the slide blocks are no longer visible. Ope-
rations have been accomplished correctly if the
actual door closes properly.
•
Close the door.
Cleaning the exterior surfaces
Before carrying out any cleaning operations, turn off the
power at the main circuit breaker.
power at the main circuit breaker.
Clean the stainless steel surfaces using warm soapy
water; never use detergents containing abrasive sub-
stances nor steel scrapers, common wire wool, brushes
or scrapers; rinse thoroughly using a wet cloth and care-
fully wipe dry.
water; never use detergents containing abrasive sub-
stances nor steel scrapers, common wire wool, brushes
or scrapers; rinse thoroughly using a wet cloth and care-
fully wipe dry.
Clean the control panel using a soft damp cloth and a
neutral detergent if necessary.
neutral detergent if necessary.
Do not wash the appliance using direct or high-pressure
water jets. To reduce the emission of pollutants into the
environment, clean the appliance (externally and where
necessary internally) with products having a biodegrada-
bility of over 90%.
water jets. To reduce the emission of pollutants into the
environment, clean the appliance (externally and where
necessary internally) with products having a biodegrada-
bility of over 90%.
Leave the door opened whenever the appliance is not in
use.
use.
D5
MAINTENANCE
DELIMING
WARNING
: DELIMING SOLUTION, RINSE
AGENTS OR ANY OTHER KIND OF ACID MUST
NOT COME IN CONTACT WITH BLEACH OR
RINSE SOLUTION CONTAINING BLEACH USED
IN CHEMICAL-SANITIZING MACHINES. MIXING
MAY CAUSE HAZARDOUS GAS TO FORM. THIS
ENTIRE PROCEDURE MUST BE FOLLOWED
STEP BY STEP FOR SAFE AND SATISFACTORY
RESULTS.
NOT COME IN CONTACT WITH BLEACH OR
RINSE SOLUTION CONTAINING BLEACH USED
IN CHEMICAL-SANITIZING MACHINES. MIXING
MAY CAUSE HAZARDOUS GAS TO FORM. THIS
ENTIRE PROCEDURE MUST BE FOLLOWED
STEP BY STEP FOR SAFE AND SATISFACTORY
RESULTS.
DELIME THE POTWASHER ON A REGULAR BASIS
AS REQUIRED. The regurarity will depend on mineral
content of the supply water. Deliming should be done
when you can see clear signs of lime deposits (a white,
chalky substance) on the inside walls and on the wash
arms. If deliming is necessary, a deliming agent should
be used for best results.
AS REQUIRED. The regurarity will depend on mineral
content of the supply water. Deliming should be done
when you can see clear signs of lime deposits (a white,
chalky substance) on the inside walls and on the wash
arms. If deliming is necessary, a deliming agent should
be used for best results.
Step 1 - Discarge tank dirty water
Open the door and remove any baskets that are in
chamber.
chamber.
Remove tank filters “C”-”D”-”E” and overflow “W”
(Figure 23).
(Figure 23).
Figure 23
M
U
S
S
S
W
C
D
E