APC ups network management card 2 ap9630 ユーザーズマニュアル

Note: Disregard the procedures described in this chapter if you 
have APC InfraStruXure

®

 Central or InfraStruXure Manager as part 

of your system. See the documentation for your InfraStruXure 
device for more information.

You must configure the following TCP/IP settings before the Network 
Management Card can operate on a network:

•  IP address of the Network Management Card

•  Subnet mask

•  Default gateway

Note: If a default gateway is unavailable, use the IP address of a 
computer that is located on the same subnet as the Network 
Management Card and that is usually running. The Network 
Management Card uses the default gateway to test the network 
when traffic is very light. 

Caution: Do not use the loopback address (127.0.0.1) as the 
default gateway address for the Network Management Card. It 
disables the card and requires you to reset TCP/IP settings to their 
defaults using a local serial login.

See “Watchdog Features” in the “Introduction” of the Network 
Management Card User’s Guide for more information about the 
watchdog role of the default gateway.

Use one of the following methods to define the TCP/IP settings needed by the 
Network Management Card:

•  APC Device IP Configuration Wizard (See “APC Device IP 

•  BOOTP or DHCP server (See “DHCP and BOOTP configuration” on 

•  Networked computer (See “Local access to the command line interface” 

on page 11 or “Remote access to the command line interface” on 
page 12.)