APC ups network management card 2 ap9630 ユーザーズマニュアル

Management Card can be configured to ignore DHCP offers that do not 
encapsulate the APC cookie in DHCP option 43 using the following 
hexadecimal format. (The Card does not require this cookie by default).

Option 43 = 01 04 31 41 50 43

where 

– the first byte (01) is the code
– the second byte (04) is the length
– the remaining bytes (31 41 50 43) are the APC cookie.

See your DHCP server documentation to add code to the Vendor 
Specific Information option. 

Note: By selecting the Require vendor specific cookie to accept 

DHCP Address check box in the Web interface, you can require the 
DHCP server to provide an “APC” cookie which supplies 
information to the Management Card: Administration > 
Network>TCP/IP>ipv4 settings.

You can use a computer connected to the serial port on the front of the Network 
Management Card to access the command line interface.

1.    Select a serial port at the local computer, and disable any service that uses 

that port.

2.    Use the provided serial cable (APC part number 940-0299) to connect the 

selected port to the serial port on the front panel of the Network 
Management Card.  

3.    Run a terminal program (such as HyperTerminal) and configure the 

selected port for 9600 bps, 8 data bits, no parity, 1 stop bit, and no flow 
control. Save the changes.

4.    Press 

E

NTER

, repeatedly if necessary, to display the User Name prompt.

5.    Use apc for the user name and password.

See “Command line interface” on page 13 to finish the 
configuration.