Zebra 49834 ユーザーズマニュアル

Print Server LCD Displays

57518L-001 Rev. A

3/18/05

170PAX4 Maintenance Manual

97

This parameter selects the part of the IP address that is considered to be 
part of the local network. It can be reached without going through the 
default gateway.

Press the left oval to move to the next digit position.

Press the right oval to increase the value of the digit.

This parameter allows you to select the IP address that the network traffic 
is routed through if the destination address is not part of the local network.

Press the left oval to move to the next digit position.

Press the right oval to increase the value of the digit.

This parameter cannot be changed through the front panel.

This parameter cannot be changed through the front panel.

• Press the right or left oval to display other choices.

Default: OPEN

Selections: OPEN, SHARED

LEAP is an encryption method that is available with some wireless cards. 
Set the LEAP user name and password through the print engine web 
pages.

• Press the right or left oval to display other choices.

Default: OFF

Selections: ON, OFF

• Press the right or left oval to display other choices.

Default: OFF

Selections: OFF, 40-BIT, 128-BIT

1 Appears only when the ZebraNet Wireless Print Server is installed.

2 These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the 

print server is recognized, all zeroes (000.000.000.000) will display until the print engine obtains an IP address or defaults 
to address 192.168.254.254.

3 If a wireless password is set, you must enter the wireless password (not the print engine password) to access this parameter.

4 This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the 

card supports LEAP.

SUBNET MASK
000.000.000.000

DEFAULT GATEWAY

000.000.000.000

MAC ADDRESS
000000000000

ESSID

125

AUTH. TYPE
OPEN

LEAP MODE
OFF

ENCRYPTION MODE

OFF