DJI Phantom 3 Standard (Factory Refurbished) オーナーマニュアル

Aircraft

Phantom 3 Standard

User Manual

The aircraft will automatically descend and land if Failsafe RTH is triggered when the aircraft

is within a 20 meter (65 feet) radius of the Home Point. During the RTH procedure, if you move

the throttle stick after the aircraft rises above 65 feet (20m), the aircraft will stop ascending and

immediately return to the Home Point.

The aircraft cannot Return-to-Home if the signal is weak ( [

] is grey).

The aircraft cannot avoid obstacles during the Failsafe RTH procedure, and therefore it is

important to set a suitable Return-to-Home altitude before each flight. Go to the DJI GO app >
Camera View > > Advanced Settings > Failsafe Mode to set the Failsafe altitude.

Failsafe RTH

Failsafe RTH will be triggered if the remote controller signal is lost for more than three seconds, provided

that a Home Point was recorded previously. You can regain control of the aircraft if the remote controller

signal is recovered.

① Record the Home Point

Aircraft Status Indicator:

Flashing Yellow Flashing Green

② Flying

Aircraft Status Indicator:

Flashing Green

③ Remote Controller Signal Lost

Aircraft Status Indicator:

Flashing Yellow

④ Signal Lost > 3s, Return-to-Home

Aircraft Status Indicator:

Flashing Yellow

>3s

⑥ Auto Landing after Hovering for 15s

Aircraft Status Indicator:

Flashing Yellow

Failsafe RTH Illustration

⑤ Return to the Home Point

Aircraft Status Indicator:

Flashing Yellow

Height over Home Point >20m

Ascend to 20m

Height over Home Point <=20m

20m

20米

The aircraft cannot avoid obstruction during the Failsafe RTH, therefore, it

is important to set an suitable Failsafe altitude before each flight. Launch

the DJI GO app and enter “Camera” and select “MODE > Advanced

Settings > Failsafe mode” to set the Failsafe altitude.

20 m

If the aircraft is flying under 20 meters (65 feet) and Failsafe (including

Smart RTH, Lower Battery RTH ) is triggered, the aircraft will first

automatically ascend to 20 meters (65 feet) from the current altitude. You

can only cancel the ascending by exiting the Failsafe. Refer to “Remote

Controller Operation” on page 23 for more information on how to exit the

Failsafe and regain the control of the remote controller.

20 m

Aircraft automatically descends and lands if RTH is triggered when the

aircraft flies within a 20 meters (65 feet) radius of the Home Point. Aircraft

will stop ascending and immediately return to the Home Point if you move

the throttle stick if the aircraft reaches 20 meters (65 feet) altitudes or

beyond during Failsafe.

Failsafe Safety Notices