Zonoff Inc. EMBY001 ユーザーズマニュアル

The Cooper Plug-In Dimming Module provides ON/OFF/DIM/BRIGHT control for freestanding incandescent lights locally and 
through TaHomA. Once installed, connected lights can be dimmed to preset levels just like overhead lights as part of Scenes 
or as needed by the End User. The module standard plugs into any 120V AC outlet. As part of TaHomA’s Z-Wave mesh 
network, the module will act as a repeater, ensuring commands will be transmitted regardless of obstacles or dead spots. 

NOTE: Only 1 device at a time can be included into TaHomA. 

1.  Make sure the module is not included by confirming the Status LED is blinking amber.

2.  Ensure lamp to be plugged into module is functioning properly.  Plug lamp into module.

3.  Plug the module into a live 120VAC wall outlet. If the outlet is controlled by a wall switch, the switch must be kept ON 

at all times.

4.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

5.  Briefly press and release the CONTROL SWITCH. The LED will stop blinking and turn off. Once the Device Finder window

displays the message “Found a Device” and the Name and Room drop down menus appear, the module has been 
successfully included in the TaHomA system.

LED is Blinking AMBER: Module has power, but is not 
included in TaHomA. 

LED is Green: Connected load is ON.

LED is OFF: Connected load is OFF.

300W Plug-In Dimming Module

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

6.  In the Device Editor window, enter a name for the module and assign it to a room.

7.  The module is now fully included in the network and can be controlled by TaHomA. Remember to activate the 

connected device through TaHomA’s Device Configurator to confirm successful programming.

NOTE: If the module is relocated while included in TaHomA, run “Rediscover Z-Wave Network” in TaHomA’s Device 
Configurator. For more information on this feature, refer to the

Advanced Features section of this guide.

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the CONTROL SWITCH. TaHomA will remove the module from the system and the icon will

disappear from TaHomA. Once removed from the system, the module’s Status LED will start blinking, indicating it is no 
longer included in TaHomA.

ON/OFF: Pressing the top or bottom of the CONTROL SWITCH will turn the connected load ON and OFF.

TO BRIGHTEN/DIM: Press and hold the top/bottom of the CONTROL SWITCH to bring lights to desired level. 

300W Plug-In Dimming Module 

cont’d