Zonoff Inc. EMBY001 ユーザーズマニュアル

EVOLVE™

EVOLVE™

The Evolve 500W Dimmer replaces regular switches and dimmers and provides ON/OFF/DIM/BRIGHT control locally and 
through TaHomA. The Evolve 500W Dimmer must be installed by a professional electrician as per the manufacturer’s 
instructions included with the device. As part of TaHomA’s Z-Wave mesh network, the dimmer will act as a repeater, 
ensuring commands will be transmitted regardless of obstacles or dead spots. 

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  Make sure the dimmer correctly controls all connected loads before including into TaHomA.

2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  Briefly press and release the DIM/BRIGHTEN PADDLE BUTTON. Once the Device Finder window displays the message

“Found a Device” and the Name and Room drop down menus appear, the dimmer has been successfully included into 
the TaHomA system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

4.  In the Device Editor window, enter a name for the dimmer and assign it to a room.

5.  The dimmer is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

dimmer through TaHomA’s Device Configurator to confirm successful programming.

LED is GREEN: Attached load is OFF. 

LED is OFF: Attached load is ON.

500W Dimmer

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Quickly tap the DIM/BRIGHTEN PADDLE BUTTON twice. TaHomA will remove the dimmer from the system and the icon will 

disappear from TaHomA. 

ON/OFF: Press the top or bottom of the DIM/BRIGHTEN PADDLE BUTTON button to toggle between ON and OFF. 

TO BRIGHTEN/DIM: Press and hold the top/bottom of the DIM/BRIGHTEN PADDLE button to bring lights to desired levels.

To change a bulb connected to this dimmer, pull out the AIR GAP SWITCH. This will cut power to the dimmer and allow you to 
change the bulb. Push the switch back into place to resume normal control.

500W Dimmer 

cont’d