Zonoff Inc. EMBY001 ユーザーズマニュアル

EVOLVE™

EVOLVE™

The Evolve Thermostat replaces regular thermostats to integrate HVAC control into TaHomA. The thermostat must be installed 
by a licensed professional as per the manufacturer’s instructions included with the device. As part of TaHomA’s Z-Wave 
mesh network, the thermostat will act as a repeater ensuring commands will be transmitted regardless of obstacles or dead 
spots. Compatible with most HVAC systems including:

•  Central HVAC systems or separate heating/cooling systems with separate RH/RC transformers (split)

•  Standard gas/electric HVAC Systems: 2-stage heating, 2-stage cooling

•  Heat Pump HVAC Systems: 3-stage heating, 2-stage cooling

•  Fan system: Selectable for gas or electric heat systems

•  Heat Pump Change Over valve (reversing valve): Selectable for change over with heat or change over with cool (O or B 

output)

•  Emergency Heat: In Heat pump mode, Emergency Heat mode is selectable from the thermostat

•  Compressor short cycle protection delay of 6 minutes (adjustable)

•  Automatic heating and cooling chang eover

•  Fan Cycler feature

Thermostat

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Put the thermostat into programming mode by pressing the corresponding MENU button, then use the blue down arrow 

to navigate to “Z-Wave Install.” Press the corresponding SELECT button. 

2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  The thermostat will ask if you want to “Add thermostat to Z-Wave Network.” Press the red arrow to indicate “yes” for 

Z-Wave inclusion. Once the Device Finder window displays the message “Found a Device” and the Name and Room 
drop down menus appear, the thermostat has been successfully included into the TaHomA system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

4.  In the Device Editor window, enter a name for the thermostat and assign it to a room.

5.  The thermostat is now fully included in the network.

1.  In the Scene Configurator, add the thermostat to your desired Scene.

2.  Click on the thermostat’s icon and check the “Change Temp” box.

3.  Select mode (Cool or Heat) and use arrows to set temperature at desired level.

4.  Choose Normal or Energy Savings

 Normal: cooling or heating only, on all the time.
 

Energy Savings: set desired temperature and TaHomA will turn the HVAC on and off to maintain your preferred settings.

5.  Close the thermostat window and save your changes. Repeat steps as necessary to add thermostat settings for as many 

Scenes as you like.

Thermostat 

cont’d