Zonoff Inc. EMBY001 ユーザーズマニュアル

EVOLVE™

EVOLVE™

NOTE: Only 1 device at a time can be excluded from TaHomA.

1.  Put the thermostat into programming mode by pressing the corresponding MENU button, then use the blue down arrow 

to navigate to “Z-Wave Install”. Press the corresponding SELECT button. 

2.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step. 

3.  The thermostat will ask if you want to “Remove Thermostat from Z-Wave Network.” Press the red arrow to indicate 

“yes” for Z-Wave exclusion.

4.  TaHomA will remove the thermostat from the system and the icon will disappear from TaHomA.

Thermostat 

cont’d

EVOLVE™

The Evolve 15A Plug-In Appliance Module provides ON/OFF control of appliances, motor loads up to 1/2HP, or freestanding 
lights locally and through TaHomA. Once installed, devices plugged into the module can be controlled as part of Scenes or 
as needed by the End User. Features a pass-through outlet (not controlled) and plugs into any standard 120V AC outlet. As 
part of TaHomA’s Z-Wave mesh network, the Plug-In Appliance Module will act as a repeater, ensuring commands will be 
transmitted regardless of obstacles or dead spots. 

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Ensure device to be plugged into module is functioning properly. Plug device into module.

2.  Plug the module into a live 120VAC wall outlet. If the outlet is controlled by a wall switch, the switch must be kept ON 

at all times.

3.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

4.  Briefly press and release the ON/OFF button. Once the Device Finder window displays the message “Found a Device” and

the Name and Room drop down menus appear, the module has been successfully included into the TaHomA system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

15A Plug-In Appliance Module