Zonoff Inc. EMBY001 ユーザーズマニュアル

®

NOTE: Only 1 device at a time can be removed from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the ON/OFF BUTTON. TaHomA will remove the receptacle from the system and the icon will

disappear from TaHomA. 

Pressing the ON/OFF BUTTON will act as a toggle switch and turn the devices connected to the Controlled outlet on or off. Devices 
connected to the Always Powered outlet will not be affected.

Please be mindful when using TaHomA’s scheduling capabilities when managing unattended devices.

Duplex Receptacle 

cont’d

The Leviton Plug-In Appliance Module provides ON/OFF control of appliances, motor loads up to 1/2HP, and freestanding 
lights locally and through TaHomA. Once installed, devices plugged into the module can be controlled as part of Scenes or 
as needed by the End User. The module plugs into any standard 120V AC outlet. As part of TaHomA’s Z-Wave mesh network, 
the Plug-In Appliance Module will act as a repeater, ensuring commands will be transmitted regardless of obstacles or dead 
spots.

NOTE: Only 1 device at a time can be included into TaHomA. 

1.  Ensure the device to be plugged into module is functioning properly. Plug device into module.

2.  Plug the module into a live 120VAC wall outlet. If the outlet is controlled by a wall switch, the switch must be kept ON 

at all times. 

3.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

4.  Briefly press and release the ON/OFF BUTTON. Once the Device Finder window displays the message “Found a Device” and

the Name and Room drop down menus appear, the module has been successfully included into the TaHomA system.

If the Device Finder window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

LED is Green: Connected load is OFF.

LED is OFF: Connected load is ON.

LED is Flashing Amber: Module is communicating 
with TaHomA.

LED is Solid Red: Communication error.

15A Plug-In Appliance Module