Zonoff Inc. EMBY001 ユーザーズマニュアル

6.  The module is now fully included in the network and can now be controlled by TaHomA. Remember to activate the 

connected device through TaHomA’s Device Configurator to confirm successful programming.

NOTE: If the module is relocated while included in TaHomA, run “Rediscover Z-Wave Network” in TaHomA’s Device 
Configurator. For more information on this feature, refer to the

Advanced Features section of this guide.

NOTE: Only 1 device at a time can be removed from TaHomA.

1.  In TaHomA’s Device Configurator, click the “Remove Device” button. Wait until the Device Remover window displays the

message “Listening for a device to remove from the network” before continuing to the next step.

2.  Briefly press and release the ON/OFF BUTTON. TaHomA will remove the module from the system and the icon will

disappear from TaHomA. 

ON/OFF: Pressing the ON/OFF BUTTON will act as a toggle switch and turn the connected lights ON or OFF. 
TO BRIGHTEN/DIM: Press and hold the ON/OFF BUTTON to bring lights to desired levels.

NOTE: The lights will turn ON at full brightness regardless of last level set.

300W Plug-In Dimming Module 

cont’d

This Motion Sensor uses Passive Infrared (PIR) to detect motion. Once installed as per the manufacturer’s instructions and 
included in TaHomA, the Motion Sensor can be used to trigger Scenes. 

NOTE: Only 1 device at a time can be included into TaHomA.

1.  Make sure the motion sensor is powered but is not yet included in TaHomA by verifying that the Status Indicator LED 

blinks white and the sensor LEDs are blinking red.

2.  In TaHomA’s Device Configurator, press the “Start Listening” button. Wait until the Device Finder window displays the

message “Listening for a device to add to the network” before continuing to the next step.

3.  Briefly press and release the ACTIVATOR Button. Once the Device Finder window displays the message “Found a Device”

and the Name and Room drop down menus appear, the motion sensor has been successfully included into the TaHomA 
system.

If the Device Editor window hangs in the “Listening for device” state, you may be out of range of the TaHomA 
controller, in which case, you will have to use the USBIC for programming (refer to page 69 for more information 
about the USBIC).

4.  In the Device Editor window, enter a name for the motion sensor and assign it to a room. The motion sensor is now part of the 

TaHomA system and can be configured in the Event Configurator.