SmartSight Networks Inc MF24 ユーザーズマニュアル
36
_____________________________________________________________________________________________
_____________________________________________________________________________________________
___________________________________________________________________
Figure 18 – Diagnostic window
4.7 Miscellaneous
4.7.1 Factory Reset (same as hardware switch SW1; see chapter 1)
This reset will bring back all factory settings including; module extension and
radio frequencies. For these reasons, a module reset this way may disappear
from the network list. You may need to configure this module locally. For the
reset to occur, you must select ‘Factory Reset’ from the drop down list and then
select ‘Unit Reset’ from this same list. Selecting ‘Factory Reset’ only will not
reset the module.
radio frequencies. For these reasons, a module reset this way may disappear
from the network list. You may need to configure this module locally. For the
reset to occur, you must select ‘Factory Reset’ from the drop down list and then
select ‘Unit Reset’ from this same list. Selecting ‘Factory Reset’ only will not
reset the module.
NOTE: The video settings are not affected by the Factory Reset.
4.7.2 Unit Reset (same as hardware switch SW2; see chapter 1)
This function selected alone (not preceded by ‘Factory Reset’) will perform a
software reset on the unit selected in the network list. Most of the time, it is going
to be used in the troubleshooting procedures.
software reset on the unit selected in the network list. Most of the time, it is going
to be used in the troubleshooting procedures.