IKUSI ELECTRONICA S.L. RAD-TF ユーザーズマニュアル

 

 
 

 
A few simple checks can bring to light certain defects which can later be the cause of 
subsequent break-downs and which can be readily rectified. We recommend the following 
checks to be made from time to time: 
 
Transmitter: 
 

 Check the transmitter’s closing screws to make sure they are securely tightened. 
 Check the rubber protection seals on the transmitter’s command buttons from time to 

time. Replace them if they are found to have deteriorated. This will protect the unit’s 
watertightness. 

 Keep the battery contacts clean. 

 
 
Receiver: 
 

 Check to make sure the cable fixture screws are tight. 
 Check the contacts on the fuses and the fuse-holders. 

 
 
Battery charger and batteries: 
 

 Keep all contacts clean. 

 

 
The transmitter and receiver both have status monitoring LEDs which help to identify 
irregularities. The most common signals are contained in the tables below: 
 

 

Green double flashing 

Transmitter ready for start-up 

Solid green 

Transmitter transmitting normally 

Red flashing 

Battery level low 

Red double flashing 

Transmitter cannot start up because a manoeuvre 
command is present 

Solid red 

Transmitter failure 

 
 
 

 

RADS11 and RADF13 Users Manual ver0.4a.doc 
KCI Hoists Corp.  reserves the right to modify this information without prior notification. 

Page 19 of 23