Norsat International Inc. NSLK3200 ユーザーズマニュアル
Norsat NewsLink
099-20003-01OM
Norsat
Page 33
Opening the Baseband/IF Unit Case
1.
Position the Baseband/IF unit case such that the arrow label on the unit
points upward.
points upward.
2.
Unfasten the four latches that attach the case end caps:
i.
Lift the winglever and turn it counter-clockwise.
ii.
After unlatched, fold in the winglever until it is once again flush with
the latch mechanism.
the latch mechanism.
C
AUTION
The Baseband/IF unit and all of its parts are not rated as water resistant, and
therefore must always be sheltered from rain or any other sources of water.
Failure to do so could result in terminal system damage, and/or serious injury
to the user due to electrical hazards.
therefore must always be sheltered from rain or any other sources of water.
Failure to do so could result in terminal system damage, and/or serious injury
to the user due to electrical hazards.
3.
Extend the laptop tray by turning the side knobs counter-clockwise, and
then pulling the unit forward; refer to Figure 27 on page 33.
then pulling the unit forward; refer to Figure 27 on page 33.
FIGURE 27.
Extending Laptop Tray.
Baseband/IF Unit Cable Connections
1.
Connect one end of the power cord to the Baseband/IF unit and the other
end to the power source; refer to Figure 28 on page 33.
end to the power source; refer to Figure 28 on page 33.
FIGURE 28.
Power Cord Connector on Baseband/IF Unit.
Antenna and Baseband Unit Interconnections
The following steps describe the procedure for interconnecting the Antenna
and Baseband units.
and Baseband units.
C
AUTION
All connections/disconnections should be made while the power is off.