VESSCO inc TX-300F ユーザーズマニュアル

 

4 

 

SECUMAN will automatically dial up to 9 telephone numbers and pager 
numbers and deliver one of two different messages when triggered by an 

alarm system. 
 

Each of nine numbers can be programmed for up to 32digits (including 

pound  tones  and  pauses  used  in  pager  numbers).  The  unit  will 

automatically skip any blank numbers. 
 
To program telephone   

 

1.  Turn  the  power  switch  “ON”.  The  LCD  of  the  SECUMAN  will 

indicate which mode the unit is in (OFF or OPERATE Mode).   

2.  To change mode, press MODE button (OFF Mode  →  TEST Mode

→ OPERATE Mode  → OFF Mode). In the OFF mode, press the 

“ME” button over 2 seconds to select the PROGRAM mode.   

3.  Continue programming per the following sections. 

 
To store telephone numbers  

4.  Insert PASS NUMBER (Default “0000”) and press # button. 
5.  Press all of the digits of first phone number. The LCD will display 

every number is pressed 

6.  Momentarily press  M E   (MEMORY) Button after the entire phone 

number has been entered, then press the  “1”key. This number is 
now stored in memory location 1. 

7.  For memory 2, press all the digits for the second phone number. 

Momentarily press  M E   (MEMORY) Button after the entire phone 

number has been entered, then press the “2” key. This number is 
now stored in memory location 2. 

8.  Repeat this process for memory location 3, 4, 5, 6, 7, 8 and 9, if 

you need.