Sensors & Software Inc. NG250 ユーザーズマニュアル
4-SmartCart Assembly
Noggin
10
4.4 Attaching the Swivel Adapters (Noggin 250, 500 & 1000)
Before the Noggin 250, 500 or 1000 can be attached to the SmartCart, the 4 swivel adapters
(with attached Clevis pins) must be attached to the mounting posts on the Noggin (see Figure 2-
1). The swivel adapters may have been attached to the Noggin at the factory. If not, follow the
instructions below.
(with attached Clevis pins) must be attached to the mounting posts on the Noggin (see Figure 2-
1). The swivel adapters may have been attached to the Noggin at the factory. If not, follow the
instructions below.
Set the swivel adapter down on the post. It may be necessary to loosen the Allen (hexagonal)
screw before the swivel adapter will slide down into the proper position. This can be done using
the 1/8” Allen (hexagonal) wrench provided. Now, tighten each screw and then loosen ¼ turn so
that the swivel adapters are firmly attached to the post but can still rotate. DO NOT OVER-
TIGHTEN!
screw before the swivel adapter will slide down into the proper position. This can be done using
the 1/8” Allen (hexagonal) wrench provided. Now, tighten each screw and then loosen ¼ turn so
that the swivel adapters are firmly attached to the post but can still rotate. DO NOT OVER-
TIGHTEN!
Figure: 4-8 Attaching the swivel adapters to the Noggin.