Z Com Inc XG621 ユーザーズマニュアル
16
After entering the WEP keys in the key field, click the Apply button and then click the OK button to
make the setting take effect.
Important: The WEP key must be set up exactly the same on the Wireless LAN stations as they
are on the wireless Access Points.
make the setting take effect.
Important: The WEP key must be set up exactly the same on the Wireless LAN stations as they
are on the wireless Access Points.
Security
Enable WEP
Encryption
Encryption
Enables the data encryption for the wireless node. To disable the
data encryption (by unchecking the box) is to not use any
encryption; this is also called Open System data encryption. To
enable encryption is to use the
data encryption (by unchecking the box) is to not use any
encryption; this is also called Open System data encryption. To
enable encryption is to use the
Shared Key data encryption method.
Key Length
The key length must be the same between all wireless nodes and
access points in the same network. The possible values for the data
encryption level are 64 bits and 128 bits. The 64-bit data encryption
is also called 40-bit data encryption by some vendors.
access points in the same network. The possible values for the data
encryption level are 64 bits and 128 bits. The 64-bit data encryption
is also called 40-bit data encryption by some vendors.
First
Second
Third
Fourth
Second
Third
Fourth
Keys
used to encrypt/decrypt wireless data. When set to 64-bit (also
called 40-bit) or 128-bit data encryption mode, you may specify up
to four different keys to encrypt wireless data.
to four different keys to encrypt wireless data.
AP Browser
By clicking the Re-scan button, the AP Browser can display Access Points around the working
environment. Besides showing the SSID and MAC Address of each Access Point, it also displays
Channel, Signal, Security and Mode.
To join any of the displayed Access Points, highlight the Access Point you desire to connect and
then click the Join SSID. Furthermore, you also could monitor the Scanning status.
environment. Besides showing the SSID and MAC Address of each Access Point, it also displays
Channel, Signal, Security and Mode.
To join any of the displayed Access Points, highlight the Access Point you desire to connect and
then click the Join SSID. Furthermore, you also could monitor the Scanning status.