Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Management
Tsunami
®
800 & 8000 Series - Software Management Guide
209
•
Password: Type the password to authenticate the Trap Server. The following special characters are not allowed in the
password: - = \ “ ‘ ? / space
password: - = \ “ ‘ ? / space
: Applicable only to SNMP v1-v2c.
•
Comment: Type comments, if any.
•
Entry Status: Select the entry status as either Enable or Disable. If enabled, the device will send SNMP traps to the
authenticated Trap Server.
authenticated Trap Server.
•
After configuring the required parameters, click Add and then COMMIT.
6.3.3.2 Edit SNMP Trap Host Table
Edit the desired SNMP Trap Host Table entries and click OK, COMMIT and then REBOOT.
6.3.4 Logs
The device supports two types of log mechanisms:
1. Event Log: Based on the configured event log priority, all the log messages are logged and used for any analysis. This
log messages remain until they are cleared by the user.
2. Syslog: They are similar to Event logs except that they are cleared on device reboot.
To configure Event log and Syslog priority, navigate to MANAGEMENT > Services > Logs. The following screen appears:
Figure 6-23 Logs
•
Event Log Priority: By default, the priority is set to Notice. You can configure the event log priority as one of the
following:
following:
– Emergency
– Alert
– Critical
– Error
– Warning
– Notice