Manualsbrain.com
  1. マニュアル
  2. ブランド
  3. Proxim Wireless Corporation
  4. XB92WFR
  5. ユーザーズマニュアル

Proxim Wireless Corporation XB92WFR ユーザーズマニュアル

ダウンロード
ページ / 336
Management
Tsunami
®
 800 & 8000 Series - Software Management Guide 
210
– Info
– Debug
Please note that the priorities are listed in the order of their severity, where Emergency takes the highest severity and
Debug the lowest. When the log priority is configured as high, all the logs with low priority are also logged. For
example, if Event Log Priority is set to Notice, then the device will log all logs with priorities Notice, Warning, Error,
Critical, Alert and Emergency.
•
Syslog Status: By default, Syslog Status is enabled and default priority is Critical. If desired, you can choose to
disable.
•
Syslog Priority: Configuration is same as Event Log Priority.
•
After configuring the required parameters, click OK and then COMMIT.
6.3.4.1 Configure a Remote Syslog host
Configure a syslog host (server) in order to forward syslog messages to it. 
: You can configure only one syslog host.
Follow the following steps to configure a remote syslog host:
1. Click Add in the Syslog Host Table screen. The Syslog Host Table Add Row screen appears:
Figure 6-24 Syslog Host Table Add Row
2. IP Address: Based on the IP mode, enter IPv4 or IPv6 address of the Syslog host.
           
: IPv6 address should be the global IP address and not the link local IP address.
3. Host Port: Represents the port on which the Syslog host listens to the log messages sent by the device. The default
port is 514. 
 
           
: The user must configure the correct port number on which the Syslog host is running. Choice of port number 
must be in line with the standards for port number assignments defined by Internet Assigned Numbers 
Authority (IANA).
4. Comments: Types comments, if any.
5. Click Add. The syslog host is added to the Syslog Host Table.