Proxim Wireless Corporation XB92WFR ユーザーズマニュアル
Tsunami
®
800 & 8000 Series - Software Management Guide
30
3
Device Initialization
This chapter contains information on the following:
•
—
—
—
•
—
—
—
•
3.1 Initialization
Once the device installation completes, access the device either through Web Interface, Command Line Interface, or an
SNMP Interface.
SNMP Interface.
: For installation procedure, please refer to the Hardware Installation Guide available on the Proxim’s support site at
http://my.proxim.com
.
•
To access the device by using CLI commands, connect a serial RS-232 cable to the Serial port of the device.
•
To access the device by using Web or SNMP interface, connect an Ethernet cable to the Ethernet port of the device.
For all the modes of connection, the IP address of the device should be configured. As each network is different, a suitable IP
address on the network must be assigned to the device. This IP address helps to configure, manage and monitor the device
by using Web Interface, SNMP, or Telnet/CLI. The device can be assigned a static/dynamic/auto IP address. When set to
static, the user has to set the IP address manually; if set to dynamic, the IP address is obtained dynamically from the
Dynamic Host Configuration Protocol (DHCP) server.
address on the network must be assigned to the device. This IP address helps to configure, manage and monitor the device
by using Web Interface, SNMP, or Telnet/CLI. The device can be assigned a static/dynamic/auto IP address. When set to
static, the user has to set the IP address manually; if set to dynamic, the IP address is obtained dynamically from the
Dynamic Host Configuration Protocol (DHCP) server.
By default, the device IP Address is set to 169.254.128.132. In case of QB-8250-LNK-G/QB-8250-LNK, the factory configured
IP address for End Point B is 169.254.128.131. If required, the end user can change it to the default IP address.
IP address for End Point B is 169.254.128.131. If required, the end user can change it to the default IP address.
: MP-825-CPE-50, MP-825-CPE-100, MP-835-CPE-10, MP-835-CPE-25, MP-835-CPE-50, MP-835-CPE-100 and
QB-826-EPR/LNK-100 devices does not have a Serial Port. However, the user has the flexibility to configure, manage
and monitor the device through command mode via Telnet.
and monitor the device through command mode via Telnet.
3.1.1 ScanTool
Proxim’s ScanTool (Answer ID - 1735) is a software utility that runs on Microsoft Windows machine.
By using ScanTool, a user can,
•
Scan devices (Proxim devices only) available on the network
•
ScanTool v3.0.1 scans devices based on IPv4 or IPv6 address
•
Obtain device’s IP address
•
Modify device’s IP Configuration parameters (IP Address, Address Type, Gateway and so on)