Wi Lan Inc EB04 ユーザーズマニュアル

Installation

20

 AWE 120-58 User Guide

10. Press 

Esc to go back to the Main Menu .

11. Select Logout to exit.

 At this time you may want finish configuring the unit according to your network plan. See 

, page 29 for instructions about viewing and changing various settings.

In this section, you will perform the following tasks:

•

Ensure that a basic RF link exists between a base station and a remote unit.

•

Test the basic link with Link Monitor and adjust Tx power level.

•

Perform some simple network tests.

This test ensures that a basic RF link exists between a base station and a remote unit.

Tip: First configure one unit as a base station, and then use it to test all the remote units.

➧ 

1.

Ensure that one unit is configured to a base station, select a center frequency and set the test minutes. 
See 

2.

Ensure that the other unit(s) are configured as remote units with the center frequency the same as the 
base station. See 

3.

Place the base station and a remote unit at least two meters apart with a clear line of sight between 
antennas. Point the antennas toward each other.

The quality of your digital data transmission depends greatly on the quality of your RF 

link. Always try to establish a high-quality RF link first. A high-quality RF link will 

result in high-quality data transmissions and a low BER. A low-quality RF link will result 

in low-quality data transmissions and a high bit error rate (BER). Digital data can always 

be sent across a high-quality RF link. If the RF link is of poor quality, data either cannot 

be sent at all or will contain too many errors to be useful.