GatesAir Inc. UAXFLID ユーザーズマニュアル
2-4
888-2721-001
10/6/10
WARNING: Disconnect primary power prior to servicing.
Section 2 Installation / Initial Turn-On
Maxiva UAX Transmitter Indoor System
User Manual
2.4
Installation of Components Removed for Shipment
Selected components have been removed for shipment following factory assembly and
test. These components have been packed separately and should be unpacked as needed
for reassembly. These items must be stored in a safe, climate controlled, dry location
until needed for reassembly. Save all packing material until after commissioning to
facilitate returns if needed. Notify Harris immediately if damage is noted while
unloading the shipment.
test. These components have been packed separately and should be unpacked as needed
for reassembly. These items must be stored in a safe, climate controlled, dry location
until needed for reassembly. Save all packing material until after commissioning to
facilitate returns if needed. Notify Harris immediately if damage is noted while
unloading the shipment.
The removed components include:
Removed from the front of the transmitter (and identified in Figure 1-2 on page 1-4) are
two Satellite receivers and IRD’s, router, power amplifier modules in the LPU’s and
power amplifier blocks, and the mask filter.
two Satellite receivers and IRD’s, router, power amplifier modules in the LPU’s and
power amplifier blocks, and the mask filter.
Coaxial lines into and out of the mask filter may have been removed from the rear of the
transmitter rack.
transmitter rack.
STEP 1
Install the mask filter in the front of the cabinet and secure it in
position.
STEP 2
Install the power amplifier blocks in the LPU’s and in the power
amplifier blocks. Read Section 2.4.1 Install PA Modules before
installing PA modules.
installing PA modules.
2.4.1
Install PA Modules
The PA Modules should be placed into the Low Power Unit (LPU) and Power
Amplifier Block (PAB) at this time. They should be inserted into the module slots in
which they were tested. In the LPU the PA modules are inserted with the cooling fins
up. Each module has a serial number which is recorded on the factory test data sheet as
belonging to a specific module slot, in the LPU or specific PAB block. The module slots
for each transmitter configuration are labeled as shown in Figure 2-3.
Amplifier Block (PAB) at this time. They should be inserted into the module slots in
which they were tested. In the LPU the PA modules are inserted with the cooling fins
up. Each module has a serial number which is recorded on the factory test data sheet as
belonging to a specific module slot, in the LPU or specific PAB block. The module slots
for each transmitter configuration are labeled as shown in Figure 2-3.