Laird Controls North America Inc. EXC9158A ユーザーズマニュアル
Edition 04/2007 US, Version A001, Excalibur, Subject to Technical Changes
Page: 8
3.
Putting into Operation
3.1 Transmitter
3.1.1 Transmitter Variants
Excalibur transmitters come in two housing sizes equipped with 6, 8, 10 or 12 2-step pushbuttons
3.1.2 Switching On the Transmitter:
Description
1
1
Status LEDs
2
Function pushbuttons
3
STOP pushbutton
4
ON pushbutton [1st step],
Horn pushbutton [2nd step]
5
Battery compartment [on the rear side
of the charger]
6
TransKey
⇒
The black Transkey [6], must be inserted
Warning!
Do not swap the transmitter/receiver
TransKey!
Do not swap the transmitter/receiver
TransKey!
Perform the switch-on sequence as follows
⇒
Press the ON pushbutton [4] once – Status LED [1] lights red,
⇒
Press the STOP pushbutton [3] once [1st + 2nd step] – Status LED [1] lights orange,
⇒
Press the ON pushbutton [4] again once – Statu s LED [1] lights green,
[The switch-on sequence must be completed within 10 seconds]
[The switch-on sequence must be completed within 10 seconds]
The Transmitter can now be used to control the system.
Note!
The function of the pushbutton [2] is dependent on the program stored in the TransKey
[6].
The function of the pushbutton [2] is dependent on the program stored in the TransKey
[6].
The transmitters have two-step pushbuttons. The 1st pressing point [1st step] is followed
by a second pressing point (2nd step).
by a second pressing point (2nd step).
See example pushbutton 4: ON [1st step], Horn [2nd step]