Computime Limited RC713A ユーザーズマニュアル

1. Radio Receivers are sensitive to heat. Avoid 

mounting them above heater, air conditioner 
or exposed to afternoon sun.

2. The higher the Receiver Module, the longer its

range. For good range and reliable reception, install
modules as high as practical above ground level with
antenna at top.

3. Large metal objects divert radio signals. Avoid

mounting Receiver Modules on metal wall, fence 
or near large metal objects.

4. Environmental conditions could effect the operation

of the remote control system. For example, in rain
the range may be less than normal.

5. Certain electric equipment like brush type motors 

or electronic gas heater igniters emit radio signals
and can effect the function of the Receiver Module.
Avoid mounting modules near such equipment.

6. Antenna orientation may increase or decrease the 

radio range. For best results, keep the antenna 
straight and adjust for better radio reception by 
bending the antenna near its base.

1. Attach RC713L Receiver Module to the top of an outdoor grade

junction box. Make sure the assembly is raintight.

2. Select the proper location (see Useful Information above) and

install Receiver assembly on a vertical surface or other support,
using hardware, suitable for the purpose.

3. Prepare the necessary conduit runs as required by the installation

layout and pull-in the specified conductors.

4. Follow wiring diagram A on the right, make wire connections 

as shown.

5. Turn ON power and test installation, using the ON/OFF button

on face of the Receiver Module. Replace junction box cover,
make sure the installation is secure and raintight.

6. Set code, see Operating Instructions on page 3.

2

1. Select the proper location (see Useful

Information on page 2) and install a radio
compatible timer on a vertical surface or 
other support, using hardware, suitable for 
the purpose.

2. Prepare the necessary conduit runs as required

by the installation layout and pull-in the 
specified conductors.

3. Use one of the side knock-outs and a suitable 

conduit-L, attach Model RC715L Receiver
Module to timer enclosure.

4. Follow wiring diagram B on the right, 

make wire connections as shown.

5. Turn ON power, and test installation, 

using the ON/OFF control of the timer.

1. Turn ON the main power and manually operate the load a few times, then turn load OFF.

2. Press the “Code Set” button on the face of the Receiver Module. The green light next to the button should now be

lit and stay lit for 30 seconds.

3. Hold the Transmitter close to the Receiver Module, press and hold the push button on the Transmitter that you 

choose to operate that particular Module. the red light on the Transmitter will light to indicate that it is 
transmitting. On the Receiver Module, the green light will flash rapidly after it is programmed.

To operate more than one Receiver Module with the same Transmitter button, in step 2 press the :”Code Set”  button
for each Receiver Module to be controlled. The green light next to the button will turn on. Press and hold the desired
transmitter button until all Receiver Module green lights begin to flash.
To operate Receiver Modules independently, program the Modules as shown in steps 2 and 3 but use a different
transmitter button for each Module.

3

Manual ON/OFF
Button (Model
RC713L Only)

Override Connections
(Model RC715L Only)

7. To prevent electronic interference, install Receiver

Modules as far apart as practical.

Figure 1

*Ground connections may or may not be as shown.

*

Ground connections may or may not be as shown.

*