VeriFone 1619-20XPL ユーザーズマニュアル
CONFIDENTIAL
Version A
Page 29 of 37
MasterCard® PayPass™ Contactless Transit Pilots
Installation Guide
4
New Jersey PATH Rail Installation
This procedure defines how to perform an installation of the phase 2 solution into a NJ PATH
Rail subway turnstile and CAM.
Rail subway turnstile and CAM.
4.1
Background
For NJ PATH Rail installations, the solution is to be fitted within a cabinet, the CAM,
which stands adjacent to the turnstile. The contactless reader card reader shall be
fitted on exterior of the CAM and the Secura Control Unit shall be fitted on an available
shelf within the CAM. The Secura will be attached via the solenoid cable to the
turnstile’s release mechanism. The duration of the solenoid pulse which releases the
turnstile needs to be calibrated during the installation process.
which stands adjacent to the turnstile. The contactless reader card reader shall be
fitted on exterior of the CAM and the Secura Control Unit shall be fitted on an available
shelf within the CAM. The Secura will be attached via the solenoid cable to the
turnstile’s release mechanism. The duration of the solenoid pulse which releases the
turnstile needs to be calibrated during the installation process.
4.2
What is Supplied?
The NJ PATH Rail part number is: PPCR002.
It comprises:
1.
Contactless Reader Assembly
2.
Secura Control Unit Assembly
3.
Power cable, 08826-02-R
4.
Mains cable, 08839-01-R
5.
Solenoid Cable, 08827-02-R
6.
OTI Contactless Reader Cable, 08829-01-R
7.
LED Board Cable, 08828-01-R
8.
LAN Cable, 08836-01-R
Note that where possible, cables will be pre-fitted to the assemblies
4.3
Tools Required
The following tools are required to install the VeriFone-supplied equipment for the pilot
installations.
installations.
o
5mm Allen Key
o
4.0, 5.5, 7.0 and 8.0 AF Nut Spanners
o
T25 and T30 Torx Drivers
4.4
Installation Pre-requisites
1.
An ethernet cable has been run into the CAM, terminated with a female RJ45
connection point.
connection point.
2.
A 3-Pin (110v) power socket has been run into the turnstile.
3.
The Secura is pre-loaded with the application software.
4.
A cable has been pre-fitted to the turnstile release mechanism.
5.
Any existing unused electronics have been re4moved from the CAM, i.e. the shelf is
free for the Secura Control Unit to be installed.
free for the Secura Control Unit to be installed.