Bright Box HK Limited RB3P ユーザーズマニュアル
Page 6 of 10
Over box packing
In the event that kits are packed in small boxes or in plastic bags, it might be necessary to pack them
in a bigger carton box.
in a bigger carton box.
The over pack box must be labelled in the same way as the kit box, mentioning the correct part number,
bar code and the number of kits inside.
bar code and the number of kits inside.
It is not allowed to pack different part numbers in 1 over pack box!
Pallets
All single boxes or over pack boxes must be put on one-way (non- returnable) pallets. Preferably with
the dimensions 800 mm by 1200 mm with a maximum of 1200 mm by 1800 mm.
the dimensions 800 mm by 1200 mm with a maximum of 1200 mm by 1800 mm.
All boxes must be fixed to the pallets with shrink foil or by a plastic band.
Stacking heights must comply with one of the following:
Maximum 1200mm, including pallet.
Minimum 2000mm – maximum 2350mm, including pallet.
When pallets with a maximum height of 1200mm are transported 2 high, the lower boxes must be
reinforced to prevent collapsing of the boxes.
reinforced to prevent collapsing of the boxes.
Pallets with a minimum height of 2000mm and maximum height of 2350mm have to be reinforced to
prevent collapsing of the bottom boxes.
prevent collapsing of the bottom boxes.
Reinforcements for theses pallets have to be carton corner type enforcements.
As a standard, all pallets used for shipments of parts comply to the ISPM-15 norm (Regulation of wood
packaging material in international trade).
packaging material in international trade).
Mixed pallets
When shipping small volumes of different accessories, it is allowed to stack them on 1 pallet. However
this can only be done if really necessary and providing that a big label is fixed to the concerned pallet,
clearly mentioning the quantity of each part number included on the pallet.
this can only be done if really necessary and providing that a big label is fixed to the concerned pallet,
clearly mentioning the quantity of each part number included on the pallet.
Box requirement
Kits intended for export will comply with all basic requirements as stated above and OEM guidelines.
Extra requirements for these kits are:
Carton boxes always have to be of the same size. Mixed box sizes for 1 part number are not
allowed.
allowed.
The cardboard material of the boxes has to be moister resistant to withstand overseas container
transport.
Tape applied should be moister resistant with sufficient adhesion strength to seal the special
carton box and to withstand overseas transport, without losing its performance.
carton box and to withstand overseas transport, without losing its performance.
Direct overseas shipments
In case direct shipments of goods from the supplier to overseas companies are required, the pallets
used need to be accompanied by proof of fumigation. This can be by document or by special marking
on wooden pallets.
used need to be accompanied by proof of fumigation. This can be by document or by special marking
on wooden pallets.
Merchandising goods
All merchandising goods have to comply with the general requirements stated in all other sections of
this guideline.
this guideline.