Bright Box HK Limited RB3P ユーザーズマニュアル
Page 5 of 10
CAN interface
•
Bus pins fault protection exceeds ± 36nV
•
Compatible with ISO 11898-2
•
GIFT/ICT Compliant
•
Data Rates up to 1 Mbps
•
Extended –7 V to 12 V Common Mode Range
•
High-Input Impedance Allows for 120 Nodes
•
Unpowered Node Does Not Disturb the Bus
Additions
•
Thermal Shutdown Protection
•
iNEMO inertial module (3D accelerometer and 3D gyroscope).
•
±2/±4/±8/±16 g full scale
•
±125/±245/±500/±1000/±2000 dps full scale
•
High-performance mode up to 1.6 kHz samples rate
•
Embedded temperature sensor
Packing guidelines
Basic requirements
When designing prototype packaging, it must be ensured that a safe and ergonomic handling of the
packaging is possible and that the risk of injuries at the OEM warehouse and supplier are eliminated.
packaging is possible and that the risk of injuries at the OEM warehouse and supplier are eliminated.
The packages which cannot be handled by fork-lift truck may not exceed a maximum weight of 15 Kg,
which in line with the European directive on manual handling of goods.
which in line with the European directive on manual handling of goods.
For boxes with a weight exceeding 15Kg, two bindings need to be applied to ease the carrying of the
box.
box.
Kit packing
Each accessory will be single packed in a box (unless otherwise agreed between the OEM and the
supplier), including the attachment parts. Once the Dongles are publicly offered for sale, each accessory
shall be accompanied with installation instructions and/or owner’s manuals.
supplier), including the attachment parts. Once the Dongles are publicly offered for sale, each accessory
shall be accompanied with installation instructions and/or owner’s manuals.
Small parts need to be fixed inside the box in such way that damage to other components is avoided.
Components have to be packed in such way, that they cannot break or get damaged during transport.
Each box must be sealed in such way that parts cannot be lost during the transportation.
The strength, color and type of carton must be defined case by case depending on the purpose and
the kind of accessory.
the kind of accessory.
Each kit must be labelled according the specifications.
Spare part packing
Spare parts have to be packed in a small box, unless otherwise agreed between the OEM and the
supplier.
supplier.
All components have to be packed separately per piece, unless otherwise defined by the OEM and
identified with a label. This label has to be built up according all requirements from chapter “Label
Requirements”.
identified with a label. This label has to be built up according all requirements from chapter “Label
Requirements”.
The bar code for the spare parts has to display only the part number stated on the OEM order and has
to comply with the bar code requirements.
to comply with the bar code requirements.