Zeni Lite Buoy Co. Ltd. 4180026 ユーザーズマニュアル
Configuration using proAtoN
Page 40
Status bit source
Select the source for the status information to match the method used to provide status information to the
transceiver (this is described in section 6.1.3).
transceiver (this is described in section 6.1.3).
Status bit logic
The logical sense of the physical status bit inputs (at either the basic or extended sensor interfaces) can be set
here. This allows for interface of equipment with active high or active low status outputs.
here. This allows for interface of equipment with active high or active low status outputs.
7.3.7
Alert messages
The transceiver can be configured to transmit text messages for three different alert conditions.
● An addressed or broadcast text message can be transmitted when the transceiver detects a Built In
Integrity Test (BIIT) failure.
● An addressed text message can be transmitted to an approaching vessel if the vessel comes within a
configurable distance of the transceivers location. This function is only available with Type 3 variants
and with full time receiver operation.
and with full time receiver operation.
● An addressed or broadcast text message can be transmitted when the transceiver determines that it
is off position (see section 7.3.1). This message is in addition to use of the alternate schedule for off
position reporting (if the alternate schedule is enabled) and does not replace that function.
position reporting (if the alternate schedule is enabled) and does not replace that function.
The layout of the alert messages configuration tab is provided in Figure 23.
Figure 23 Alert messages configuration tab layout
BIIT failure actions
This section allows configuration of the text message to be transmitted on detection of a Built In Integrity Test
failure (BIIT failure). Such a failure may indicate a problem with the transceiver and it may be prudent to warn
vessels not to rely on the information provided by the transceiver in this situation. Note that the health of the
transceiver is always transmitted as part of the standard Aids to Navigation position report (message #21),
however the status contained in that message may not be shown on all display systems.
The available actions on BIIT failure are:
failure (BIIT failure). Such a failure may indicate a problem with the transceiver and it may be prudent to warn
vessels not to rely on the information provided by the transceiver in this situation. Note that the health of the
transceiver is always transmitted as part of the standard Aids to Navigation position report (message #21),
however the status contained in that message may not be shown on all display systems.
The available actions on BIIT failure are:
● No action - no message is transmitted on detection of a BIIT failure
● Transmit message #14. A broadcast text message is transmitted on detection of a BIIT failure. The
● Transmit message #14. A broadcast text message is transmitted on detection of a BIIT failure. The
text content of the message must be defined in the ‘Message text’ box.
Configure BIIT failure
message action
Configure vessel
proximity alert action
Configure additional
off position alert action
Configure SART
Relay Mode