Zeni Lite Buoy Co. Ltd. 4180026 ユーザーズマニュアル

ページ / 74
Data messages and data sources
Page 52
9.2.9
 External device support
The unit currently supports the following external devices which can be configured in number of combinations
(“options”) and the data used to populate message #8 Metrological and Hydrological data.  Two formats of this
message are supported; DAC 001, FI 31 and DAC 001, FI 11.
● Airmar PB200 / 150WX Weather Station
● Impress S12C Water Pressure and Temperature gauge
● RM Young Wind Monitor
JFE Aadvantch Co. Current Meter AEM-RS
Zeni Lite GPS Wave Meter
Vaisala Weather Transmitter WXT520
Nortek AS Aquadopp Profiler 
Separate guides are available for each device detailing the connection and configuration arrangements. 
The configuration options are shown in Table 9 below.  The default configuration for Akari is ‘Option 1’
Table 9
Sensor Configuration Options 
*   this device can be connected via RS422 or RS232
** this device is connected via SDI-12 (which disables RS232 B)
The extended sensor interface can also be adapted through software changes to support almost any
equipment that might be encountered in an AtoN application. If your application requires interface to equipment
other than that listed here please contact your supplier to discuss your requirements.
Connection
RS422
RS 232 A
RS232 B
Option 0
Airmar PB200 / 150WX*
Impress Water Meter (SDI-12)**
Option 1
RM Young Wind Meter
Advantech Current Meter
Zeni Lite Wave Meter
Option 2
Viasala Weather Station
Aquadopp Current Profiler
Zeni Lite Wave Meter
Option 3
RM Young Wind Meter
Aquadopp Current Profiler
Zeni Lite Wave Meter
Option 4
Viasala Weather Station
Advantech Current Meter
Zeni Lite Wave Meter