Mesh Systems LLC DS003 ユーザーズマニュアル
P a g e
| 19
Version 1.0
DOW CONFIDENTIAL - Do not share without permission
Sensor Status LED Behaviors: During Service Interval (or Service Override)
Accelerometer Snap Detected
Red LED Flashes Three Times
Accelerometer Motion Detected
Red LED Flashes Four Times
Uninstall
Red And Green LED On Solid for One Second
If initiated via MagProx: Red LED rapidly flashes until Magnet removed
If initiated via MagProx: Red LED rapidly flashes until Magnet removed
Figure 12: Sensor Light Sequence #2: GREEN
After installation, the red and green lights will blink once every 15 seconds, indicating the Sensor is in
the install quiet period.
the install quiet period.
Step 5: For New Sensor Installations: Select Install as New if this is a new sensor location
For Replacement of an Existing Sensor: Select the existing sensor for replacement.
For sensor replacement, no additional steps are necessary. The sensor ‘adopts’ all of the
replacement sensor settings.
Figure 13: New Sensor Installation
Step 6: For New Sensors: Enter all relevant information about the Sensor. Once finished, select Save.