Ueda Japan Radio Co Ltd DSF214 ユーザーズマニュアル

⑦

Check and change settings

The current settings can be checked and changed by receive a signal from LF

equipment which selling separately. If the equipment has received a signal from the

LF equipment, the equipment transmits a data which newest contents of the setting

is put.

How to

Use

●

Initial setting

Please set up in the following procedure.

・

Put your nails on the recess and remove the battery cover of the reverse side in the

direction of the arrow.

・

Pull out a red sheet caught between the battery and the holder. The battery will be

connected, and the equipment starts operation in this state.

・

LED blinks at a start-up. (The number of times of blinking of the beginning means the

remaining battery capacity. 4 times: full ~ 1time: empty)

・

The equipment begins to operate with the default value of the factory in this

state.(924.6MHz) The equipment enters the standby mode when not transmitting,

and it becomes a state that waits for transmission or waits for receiving a signal from

LF equipment.

・

Attach the battery cover which has been removed prior.

●

Change settings

・

When you make a setting change, use LF equipment and transmit the new set value.

(Please read the instruction manual of LF equipment for details.)

・

When the equipment succeeds in receiving a LF signal from the LF equipment, LED

blinks once. Preset value is stored to the internal memory in this state.

・

The equipment transmits the set value for a confirmation.

・

The equipment begins to operate with the set condition.