Ueda Japan Radio Co Ltd DSF214 ユーザーズマニュアル
9
●
Battery Replacement
・
Put your nails on the recess and remove the battery cover of the reverse side.
・
Insert an object with a fine point such as a ballpoint pen into the notch of the reverse
side and remove the battery by shifting.
・
Turn off the safety switch once in the state after removing the battery, turn on the
switch again after wait 5 seconds.
・
Insert a new battery according to the figure of the reverse side of the battery cover
while being careful about direction of a battery.
・
LED lights up. (Remaining battery capacity information is indicated in the same
manner as described above.)
・
The equipment begins to operate with the condition set before replacing the battery.
●
Notification (LED)
・
LED is just a notification function. At the time of the LF signal reception and the
push-button switch transmission, there is a case where the transmission is not
performed by the use environment even if the LED is flashing.
●
FCC ID
・
FCC ID can be found inside of the Battery cover.
●
The others
・
In low battery voltage environment, the preset data which will be stored on internal
memory of this equipment at the time of settings may not be successfully stored.
Please check store result by transmit data, and replace the battery when the data
cannot be stored normally.