AEG AR 4025 BT 400425 ユーザーズマニュアル

75

Use the screws (B) to fasten the unit to the mounting 

 

‹

brackets (D).

Connect the audio output of an external audio device 

 

‹

to the 

AUX IN jack (21) on the front of the unit.

Select playback of the audio input by pressing the 

 

‹

MODE button (1) several times until the display shows 

AUX.

 

Before initial use of the remote control, you must 

 

►

insert the supplied batteries to prepare the remote 

control for use.

The life of the supplied batteries may be reduced 

 

►

depending on storage conditions.

Pull the battery compartment out of the remote  

 

‹

control by pressing the side catch and at the same 

time pulling out the compartment.

Insert the batteries into the battery compartment. 

 

‹

Make sure that the batteries are inserted correctly 

according to their polarity.

Slide the battery compartment back into the remote 

 

‹

control.

You can remove the control panel from your unit to  

protect against theft. Do not keep the detached panel in 

your car.

 

To protect your control panel always keep it in the 

 

►

case.

Do not touch the terminals on the unit or the  

 

►

control panel.

Firstly insert the right hand side of the control panel 

 

‹

into the frame.

Then press in the left hand side until it clicks into 

 

‹

place.

Flip up the control panel until it clicks into place.

 

‹

Check whether the control panel is inserted correctly 

 

‹

and securely into the frame. If the control panel is not 

properly fitted, the unit may not operate correctly.

Press the 

 

‹

OPEN button (7) and flip the control panel 

down.

Then carefully pull the left hand side of the control 

 

‹

panel to detach it.

The battery of the remote control is a long-life lithium 

cell. If the range of the remote control is reduced during 

use, please proceed as follows:

Pull the battery compartment out of the remote 

 

‹

control, by pressing in the side catch and pulling out 

the battery compartment at the same time.

Replace the cell by a battery of the same type (CR 

 

‹

2025). Ensure correct polarity.

Slide the battery compartment back into the remote 

 

‹

control.

If the remote control is not used for a prolonged period, 

remove the batteries in order to prevent battery acid  

leaking.

 

Do not expose the batteries to high temperatures or 

 

►

direct sunlight. Never throw batteries into the fire. 

There is a danger of explosion!

 

Do not dispose of batteries with household waste. 

 

►

Take spent batteries to a designated collection point 

or to a dealer.

This chapter provides you with important instructions on 

the operation and use of the unit.

 

Some keys are to be found both on the device itself 

 

►

and on the remote control. Keys with the same 

desig-nation have the same function. The following 

pages detail the operation of the unit.

The remote control signals are transmitted to the 

 

►

unit via infrared light. The transmission of the signals 

from the remote control to the unit may be impaired 

by direct sunlight on the IR Sensor (28) of the unit.

To switch on the unit press any button (except the 

 

‹

OPEN button (7)). This activates the display.

To switch off the unit, keep the 

 

‹

PWR/MUTE button (2) 

pressed.