Intel R2000BB4GS9 データシート
Intel
®
Server System R2000BB Product Family TPS
28
Revision 2.0
Figure 23. System Fan Assembly
The system fan assembly is designed for ease of use and supports several features.
Each fan is hot-swappable.
Each fan is designed for tool-less insertion and extraction from the fan assembly. For instructions on
installing or removing a fan module, see the Intel
installing or removing a fan module, see the Intel
®
Server System R2000BB Service Guide.
Fan speed for each fan is controlled by integrated platform management as controlled by the integrated
BMC on the server board. As system thermals fluctuate high and low, the integrated BMC firmware will
increase and decrease the speeds to specific fans within the fan assembly to regulate system thermals.
BMC on the server board. As system thermals fluctuate high and low, the integrated BMC firmware will
increase and decrease the speeds to specific fans within the fan assembly to regulate system thermals.
Each fan has a tachometer signal that allows the integrated BMC to monitor their status.
On top of each fan is an integrated fault LED. Platform management illuminates the fault LED for the
failed fan.
failed fan.
Each fan has a10-pin wire harness that connects to a matching connector on the server board.
Note: Due to cable length limitations, the system fan connector labeled “SYS_FAN_5” on the server board is
NOT used in this system. System Fan 5 will plug into the fan connector labeled “SYS_FAN_6”.
NOT used in this system. System Fan 5 will plug into the fan connector labeled “SYS_FAN_6”.
Figure 24. Server Board System Fan Connector Locations