Whirlpool 3397627C ユーザーズマニュアル

This dryer may be installed in a recessed area or closet. For 

recessed area and closet installations, minimum clearances  

can be found on the serial tag on the dryer.

The installation spacing is in inches and is the minimum 

allowable. Additional spacing should be considered for  

ease of installation, servicing, and compliance with local  

codes and ordinances.

If closet door is installed, the minimum unobstructed air  

opening in the top and bottom is required. Louvered doors  

with equivalent air openings are acceptable.

The dryer must be exhausted outdoors.

No other fuel-burning appliance may be installed in the same 

closet as the dryer.

  

    Recessed front view              Closet side view

Additional clearances for wall, door, and floor moldings may be required or if  

external exhaust elbow is used.

Louvered doors with equivalent air openings are acceptable.
*Opening is the minimum for a closet door. 

Observe all governing codes and ordinances.

A two-wire plus separate ground wire, or a 3-wire, single-phase 

230-volt, 50-Hz, AC only, electrical supply is required on a 

separate 15-amp circuit, fused on both sides of the line. A time-

delay fuse or circuit breaker is recommended.

It is the personal responsibility and obligation of the customer 

to contact a qualified electrician to assure that the electrical 

installation is adequate and is in conformance with all local  

codes and ordinances.

If codes permit and a separate grounding wire is used, it is 

recommended that a qualified electrician determine that the 

grounding path is adequate.

This dryer is equipped with a power supply cord. To minimize 

possible shock hazard, the cord must be plugged into a mating 

wall receptacle.

If your electrical requirements are different, contact your 

authorized Whirlpool service center or a qualified electrician.