Whirlpool 3397627C ユーザーズマニュアル

 

Plug power supply cord into the grounded outlet or connect 

direct wire to power supply. Turn power supply on.

It is recommended that installation should be done by a qualified 

electrician.

This dryer can be connected directly to the fused disconnect or 

circuit breaker box with two-wire or three-wire flexible, armored 

or non-metallic sheathed copper cable (with ground wire). Do Not 

use two-wire with bare ground wire. All current-carrying wires 

must be insulated.

A conduit connector must be installed at each end of the power 

supply cable (at the dryer and at the junction box.) USE ONLY 

10-GAUGE SOLID COPPER WIRE. DO NOT USE ALUMINUM 

WIRE. Allow 4 ft (1.22 m) of slack in the line so the dryer can be 

moved if servicing is ever necessary.

 

■

It is your responsibility to contact a qualified electrical installer 

to ensure that the electrical installation is adequate and in 

conformance with the National Electrical Code, ANSI/NFPA 

70, latest edition, and all local codes and ordinances.