VIZIO TL-WR641G ユーザーズマニュアル

 

 

- 39 - 

The function won't take effect until the router reboots. 

 

Figure 4-28 

There are four submenus under the Forwarding menu (shown in Figure 4-28): Virtual Servers, 

Port Triggering,  DMZ and UPnP. Click any of them, and you will be able to configure the 

corresponding function. The detailed explanations for each submenu are provided below. 

Virtual servers can be used for setting up public services on your LAN, such as DNS, Email 

and FTP. A virtual server is defined as a service port, and all requests from the Internet to this 

service port will be redirected to the computer specified by the server IP. Any PC that was 

used for a virtual server must have a static or reserved IP Address because its IP Address may 

change when using the DHCP function. You can set up virtual servers on this page, shown in 

 

Figure 4-29 

¾

  Service Port - The numbers of External Ports. You can type a service port or a range of 

service ports (the format is XXX – YYY, XXX is the start port, YYY is the end port).   

¾

  IP Address - The IP Address of the PC providing the service application. 

¾

  Protocol - The protocol used for this application, either TCP, UDP, or All (all protocols 

supported by the router). 

¾

  Status - The status of this entry either Enabled or Disabled. 

1. Click 

the Add New button.(pop-up Figure 4-29) 

2.  Select the service you want to use from the Common Service Port list. If the Common