Siemens AT Command Set Cellular Engines Wireless Modules MC35 ユーザーズマニュアル

MC35_ATC_01_V04.00

Page 198 of 238

02.04.2002

Test command

AT^SNFO=?

Response

^SNFO: (list of supported <outBbc Gain>), (list of supported <outCali-
brate[0...4] >), (list of supported <outStep>), (list of supported <sideTone>s)
OK

Parameter

See write command

Read command

AT^SNFO?

Response

Parameter

See write command

Write command

AT^SNFO=<out-
BbcGain>,<outCali-
brate[0]>,...<outCali
brate[4]>,<out-
Step>,<sideTone>

Set TA's loudspeaker path parameters.

Response

<outBbcGain> <outCalibrate[0]>...<outCalibrate[4]> <(outStep)> <sideTone>
OK

Parameters

Setting for DAC gain amplifier attenuation 0 – 3 (0=0 dB,
3=-18 dB, 4 steps of 6 dB)

Multiplication factor 0 – 32767 for output samples
Attenuation = 20 * log (outCalibrate[n]/32767)

Setting of actual volume; 0 – 4, i.e. outCalibrate[n]

Multiplication factor 0 – 32767 determining how much of
the original microphone signal is added to the earpiece
signal.
Side Tone Gain/dB = 20 * log (sideTone/32767)

Reference

Siemens

Note

•  Write command works only in audio modes 2 to 6!

•  Read and write options of this command refer to the active audio mode.

• The 

values 

<outStep> can be changed also by ^SNFV.

•  The range of <outCalibrate> is up to 65535 but will be suppressed to

32767. A value above <outCalibrate> = 65535 will cause a error

•  Changed values will not be stored automatically, but via the AT command

AT^SNFW except <outStep>. The parameter <outStep> will be saved after
AT^SMSO only.

•  The volume level as well as mute affects all audio modes.

•  In case of audio mode 1 the parameter <outStep> has no effect.

•  CAUTION! When you adjust audio parameters avoid exceeding the maxi-

mum allowed level. Bear in mind that exposure to excessive levels of noise
can cause physical damage to users!