SharkRack KVM-8 ユーザーズマニュアル
KVM-8 Installer/User Guide
12
Basic Operations
13
Keyboard Control
The following notational conventions appear throughout this chapter to illustrate
commands for operating the KVM Switch. Whenever you see one of the symbols listed
on the left side of the table, substitute the corresponding steps or values listed on the
right side of the table.
Convention
Key Sequence or Value
<CM>
Enter Command Mode:
1. Press and hold down the Num Lock key.
2. Press and release the minus (-) key on the numeric keypad.
3. Release the Num Lock key.
1. Press and hold down the Num Lock key.
2. Press and release the minus (-) key on the numeric keypad.
3. Release the Num Lock key.
Note:
For alternate hot-key sequences, see “System Control &
Maintenance” later in this chapter.
<Enter>
Press the Enter or Return key. The <Enter> command is used to
execute an instruction and exit from Command Mode.
execute an instruction and exit from Command Mode.
Addr
The numbers over the push-buttons on your KVM Switch are
your computers’ addresses. Enter the number, 1-8, for the
computer you’re selecting. For cascaded systems, enter the
address of the base unit, then the address of the cascaded unit.
Example: You have a KVM Switch unit cascaded from channel
1 of your base unit. To access the computer at channel 3 of this
second (cascaded) unit, enter 13.
your computers’ addresses. Enter the number, 1-8, for the
computer you’re selecting. For cascaded systems, enter the
address of the base unit, then the address of the cascaded unit.
Example: You have a KVM Switch unit cascaded from channel
1 of your base unit. To access the computer at channel 3 of this
second (cascaded) unit, enter 13.
<ESC>
Press the Escape key. The <ESC> command is used to exit
Command Mode without executing an instruction.
Command Mode without executing an instruction.
Keyboard Switching
One of the ways to change the active channel in a non-secured KVM Switch system is
by entering a short sequence of keystrokes on the keyboard. This is called keyboard, or
hot-key, switching.
Note: Hot-key switching is only available in the default non-secure state. For more information on
secure versus non-secure operation, see the “Administrator Functions” section of Chapter 4.
secure versus non-secure operation, see the “Administrator Functions” section of Chapter 4.
The first set of keystrokes places your system in Command Mode. A grey window with
a line for commands will appear. As long as you are operating in Command Mode,
whatever you type will be interpreted as channel switch commands until the Enter or
the Esc key is pressed to terminate Command Mode. None of the keystrokes entered
will be forwarded to the attached computer until you exit Command Mode.
Next, enter the address (Addr) for the channel you wish to select.
Next, enter the address (Addr) for the channel you wish to select.