SharkRack KVM-8 ユーザーズマニュアル

KVM-8 Installer/User Guide

14

On-Screen Display Operations

15

The following commands are used for system control and maintenance. Enter the 

command sequences to perform the actions described in the table below.

<CM>Kn<Enter>

Sets the keyboard scan set where n is a scan set number 1-3.

<CM>MR<Enter>

If you hot-plug your mouse cable, you may experience a loss of 
mouse signal. Use this command to restore the signal if you are 
using a PC with a standard PS/2 mouse driver.

<CM>MW<Enter>

If you hot-plug your mouse cable, you may experience a loss of 
mouse signal. Use this command to restore the signal if you are using 
a PC with a Microsoft IntelliMouse or other wheel mouse driver.

<CM>AV<Enter>

Displays the current firmware version of your KVM Switch.

<CM>SG<Enter>

Enables the scan Go command (by address only).

<CM>SH<Enter>

Enables the scan Halt command.

<CM>M+<Enter>

Enables mouse suspension of scanning.

<CM>M-<Enter>

Disables mouse suspension of scanning.

<CM>H1<Enter>

Changes the hot-key sequence to the default: (NumLock, -).

<CM>H2<Enter>

Changes the hot-key sequence to the 1st alternate: (NumLock, *).

<CM>H3<Enter>

Changes the hot-key sequence to the 2nd alternate:  (CTRL, ~).

<CM>OSD0<Enter>

Disables the OSD Sequence.

<CM>OSD1<Enter>

Changes the OSD sequence to the default: (CTRL, CTRL).

<CM>OSD2<Enter>

Changes the OSD sequence to the 1st alternate: (Alt, Alt).

<CM>OSD3<Enter>

Changes the OSD sequence to the 2nd alternate: (Shift, Shift).

<CM>ZM<Enter>

Use this command to resynchronize the mouse after a device or 
computer hot-plug. Repeat, if necessary, until synchronization is re-
established. 

 Using this command while the mouse is operating 

correctly will cause the mouse to lose sync.