Omnitron Systems Technology MAH 200 ユーザーズマニュアル

CODE READER MAH 200

To connect the MAH 200 to your host computer via
USB interface:

1. Make sure the USB cable is sufficiently attached to your MAH 200 unit
(figure 2.1).

2. You DO NOT need to power off your host computer (figure 2.2). The MAH 200 with USB

interface can be plugged into any host while the computer is powered up.

3. Connect the USB interface cable to the host (figure 2.3). If you are unsure of the proper location

to connect the USB cable please consult the manual of your host computer.

4. The USB interface does not require additional power supply. If you are using the 1300 mA or

1800 mA battery for batch mode, the MAH 200 will automatically recharge the battery whenever
the unit is a attached to a host that is powered up.

5. The MAH 200 will power on automatically.

6. Scan the USB Keyboard Mode code to then the Save Setting code to configure reader:

7. Your MAH 200 unit should be ready for use. Open the application (any Windows based

application that accepts Keystroke data – e.g. Notepad) you wish to send data and begin scanning.