Omnitron Systems Technology MAH 200 ユーザーズマニュアル

CODE READER MAH 200

1. Power off the host computer.

2. Attach the end of the PS2 cable with the single connector        to the MAH 200.

3. If external keyboard exists, unattach your keyboard from the host and connect the appropriate

connector to the PS2 cable      .

4. Connect the other connector to host computer into keyboard port       . The MAH 200 is powered

by the PS2 port and does not require a power supply.

5. Set the MAH 200 to PS2 mode by scanning the code below, then scan the Save Settings code:

6. Your MAH 200 unit is now ready. Open the appropriate application 

(any Windows based

application that accepts Keystroke data – e.g. Notepad) 

and begin scanning data.

Upgrade Note: The PS2 model does not work with a USB cable. If you are upgrading the
firmware you must use an RS-232 cable.

WARNING: Code does not recommend using Batch or Bluetooth Radio modes with the PS2
interface because you need to disconnect the MAH 200 and the keyboard and this may result in
the host computer freezing and requiring you to reboot.